RCBS’s Bullet Puller Collet for .416 Caliber (part number 9434) is a caliber-specific press insert built to pull jacketed bullets cleanly out of loaded brass. It uses the same 7/8-inch-14 thread as the rest of the RCBS die lineup, so it seats in any single-stage press without an adapter. Reloaders keep a set of these on hand by caliber for pulling mis-seated bullets, salvaging brass, or breaking down ammunition safely.

Key Specifications

• .416 Caliber precise fit matches the bullet diameter exactly for a secure, centered grip during the pull.
• standard 7/8-inch-14 threading so it seats in almost any single-stage reloading press without an adapter.
• newly redesigned collet body improves on earlier RCBS puller collets for smoother, more consistent gripping.
• pulls jacketed bullets without damaging the bullet or the case so both the projectile and the brass stay reusable.
• installs directly into the press die station letting you pull bullets on the same press used to load them.
• bullet releases by tightening the collet and lowering the ram a simple, repeatable motion with no special tools.
• ships at approximately 0.0813 lb light enough to keep several caliber collets on hand without adding real bench weight.

Frequently Asked Questions

What press do I need for this collet? Any single-stage reloading press that accepts a standard 7/8-inch-14 die will work; the collet threads in exactly like a sizing or seating die.

Is this collet specific to .416 Caliber, or will it work on other calibers? It’s ground to match .416 Caliber specifically. A different caliber needs its own matching collet for a secure, damage-free pull.

Buy the RCBS Bullet Puller Collet, .416 Caliber

Order the .416 Caliber collet from our Lubbock, TX gun shop with fast shipping to keep your bullet-puller kit caliber-complete. Browse our full reloading equipment selection for the rest of your bench setup.