RCBS’s Bullet Puller Collet for .375 Caliber (part number 9431) is a caliber-specific press insert built to pull jacketed bullets cleanly out of loaded brass. It uses the same 7/8-inch-14 thread as the rest of the RCBS die lineup, so it seats in any single-stage press without an adapter. Reloaders keep a set of these on hand by caliber for pulling mis-seated bullets, salvaging brass, or breaking down ammunition safely.

Key Specifications

• .375 Caliber precise fit matches the bullet diameter exactly for a secure, centered grip during the pull.
• standard 7/8-inch-14 threading so it seats in almost any single-stage reloading press without an adapter.
• newly redesigned collet body improves on earlier RCBS puller collets for smoother, more consistent gripping.
• pulls jacketed bullets without damaging the bullet or the case so both the projectile and the brass stay reusable.
• installs directly into the press die station letting you pull bullets on the same press used to load them.
• bullet releases by tightening the collet and lowering the ram a simple, repeatable motion with no special tools.
• ships at approximately 0.0813 lb light enough to keep several caliber collets on hand without adding real bench weight.

Frequently Asked Questions

Does this collet come with the puller body? No, this is the .375 Caliber collet only. You’ll need an RCBS Bullet Puller body to use it, and can swap collets between calibers as needed.

Will this damage my bullets or brass? No. The collet is designed to grip the case and let the ram draw the bullet straight out, leaving both the bullet and the case reusable.

Buy the RCBS Bullet Puller Collet, .375 Caliber

Order the .375 Caliber collet from our Lubbock, TX gun shop with fast shipping to keep your bullet-puller kit caliber-complete. Browse our full reloading equipment selection for the rest of your bench setup.