The RCBS Bullet Puller Collet for .40 Caliber (part no. 9432) is sized to grip .40 Caliber bullets inside an RCBS Standard Bullet Puller. It lets you pull a bullet cleanly out of a loaded case, whether you’re correcting a bad charge, salvaging components, or breaking down a batch of test loads, without marring the bullet enough to keep it from being reused. It works across the range of cases commonly loaded with .40 Caliber bullets, not just a single cartridge.

Key Specifications

• Sized for .40 Caliber bullets, gripping the bullet body without marring the caliber’s specific diameter.
• Designed for use with the RCBS Standard Bullet Puller, not a universal fit for every puller brand.
• Grips the bullet so an inertia pull removes it from the case without damaging the bullet for reuse.
• Works across a wide range of cases loaded with this bullet diameter, not just one specific cartridge.
• Weighs approximately 1.7 oz shipped, light enough to keep several on the bench or in a range bag.

Frequently Asked Questions

What does this collet fit? It’s sized for .40 Caliber bullets used with the RCBS Standard Bullet Puller.

Does it come with the bullet puller? No, this is the collet only; it’s designed to be used with an RCBS Standard Bullet Puller you already own.

Buy the RCBS Bullet Puller Collet .40 Caliber

Add a correctly sized collet for pulling .40 Caliber bullets. Order from our reloading equipment lineup and our Lubbock, Texas team can help confirm the fit for your bullet puller.