Talon Grips Adhesive Grip for Glock 19/23/25/32/38 (Granulate Texture)

The TALON Grips Inc adhesive grip (Talon part no. 104G) is built specifically for Glock 19/23/25/32/38 Gen1-3, replacing the factory grip texture with a granulate panel that adds virtually no bulk. Talon designs each grip as a factory-fit overlay rather than a universal wrap, so the panel lines up with the frame’s stippling breaks and controls without covering them. The granulate texture is best suited for holster carry and competition shooting, and because it is adhesive-backed rather than molded, it installs in minutes without any modification to the pistol. It is a straightforward way to improve retention on a carry or duty gun without changing anything else about the platform.

Key Specifications

• Purpose-built to fit Glock 19/23/25/32/38 Gen1-3, matching the factory grip frame contour.
• Finished in a black granulate texture.
• Covers the side panels up through the thumb rest area for a full-hand grip surface.
• Extends coverage under the trigger guard, a high-contact area the factory texture often misses.
• Wraps onto the backstrap for consistent texture across the entire grip circumference.
• Includes molded finger-groove relief so the wrap follows the trigger-guard finger grooves instead of bridging over them.
• Cut with a relief opening for the TALON logo so the factory branding stays visible after install.
• Applies as a single adhesive-backed panel, requiring no disassembly, drilling, or permanent modification.
• Installs in minutes with light heat from a hair dryer or heat gun to set the adhesive into the frame texture.
• Removes cleanly with little to no adhesive residue, returning the pistol to its factory finish if needed.

Frequently Asked Questions

What pistols does this Talon grip fit? It is purpose-cut for Glock 19/23/25/32/38 Gen1-3 and is not a universal wrap for other frames or generations.

Is the granulate texture hard to install? No — it is a single adhesive-backed panel that installs in minutes, typically with a hair dryer or heat gun to help the adhesive set into the frame, with no gunsmithing required.

Will it damage the factory finish if I remove it later? No, the adhesive is designed to release cleanly with little to no residue, so the frame returns to its original factory look.

Buy the Talon Grips Adhesive Grip for Glock 19/23/25/32/38 (Granulate Texture)

Order this Talon adhesive grip from our Talon Grips lineup in our handgun grips selection and give Glock 19/23/25/32/38 pistol better texture without changing a single factory dimension. Order it from our Lubbock, Texas gun shop for fast, direct shipping right to your door.