Talon Grips Adhesive Grip for Glock 17/22/24/31/34/35/37 (Rubber Texture)

This TALON Grips Inc black rubber adhesive grip (Talon part no. 103R) is cut to the exact frame geometry of Glock 17/22/24/31/34/35/37 Gen1-3, so it drops onto the factory grip panels with an OEM-quality fit instead of a generic wrap. Its rubber surface is comfortable against bare skin and less likely to snag on a cover garment during a draw. The grip is a single adhesive-backed panel, not a mechanical part, so no disassembly is required to fit it. It is a low-cost upgrade for shooters who want more confident purchase on the gun without altering its factory dimensions.

Key Specifications

• Purpose-built to fit Glock 17/22/24/31/34/35/37 Gen1-3, matching the factory grip frame contour.
• Finished in a black rubber texture.
• Covers the side panels up through the thumb rest area for a full-hand grip surface.
• Extends coverage under the trigger guard, a high-contact area the factory texture often misses.
• Wraps onto the backstrap for consistent texture across the entire grip circumference.
• Includes molded finger-groove relief so the wrap follows the trigger-guard finger grooves instead of bridging over them.
• Cut with a relief opening for the TALON logo so the factory branding stays visible after install.
• Applies as a single adhesive-backed panel, requiring no disassembly, drilling, or permanent modification.
• Installs in minutes with light heat from a hair dryer or heat gun to set the adhesive into the frame texture.
• Removes cleanly with little to no adhesive residue, returning the pistol to its factory finish if needed.
• Bonds securely even over a factory Rough Textured Frame (RTF) finish.
• Manufactured in the USA to Talon’s own tooling for each supported pistol model.

Frequently Asked Questions

What pistols does this Talon grip fit? It is purpose-cut for Glock 17/22/24/31/34/35/37 Gen1-3 and is not a universal wrap for other frames or generations.

Is the rubber texture hard to install? No — it is a single adhesive-backed panel that installs in minutes, typically with a hair dryer or heat gun to help the adhesive set into the frame, with no gunsmithing required.

Will it damage the factory finish if I remove it later? No, the adhesive is designed to release cleanly with little to no residue, so the frame returns to its original factory look.

Buy the Talon Grips Adhesive Grip for Glock 17/22/24/31/34/35/37 (Rubber Texture)

Order this Talon adhesive grip from our Talon Grips lineup in our handgun grips selection and give Glock 17/22/24/31/34/35/37 pistol better texture without changing a single factory dimension. Order it from our Lubbock, Texas gun shop for fast, direct shipping right to your door.