The Warne 30mm Scope Rings for the CZ 527 in high, matte finish (Warne part no. 15B1M) mount directly to the rifle’s dovetail receiver without requiring a separate base, since each CZ receiver design demands rings machined to its own exacting tolerances. Warne builds these CZ-specific fixed rings to fit the 16mm dovetail found on the CZ 527, using a CZ-specific recoil pin for positive engagement between the ring and the receiver dovetail. Four T-15 Torx-style socket cap screws, torqued to a recommended 25 in/lb, secure the scope permanently and precisely in the rings. Because the design permanently attaches to the receiver, shooters get a rock-solid mounting solution rather than a removable ring-and-base system.

Key Specifications

• Ring diameter is 30mm, sized for larger objective riflescopes.
• Ring height is high for clearance with bigger scope tubes.
• Finish is matte for a low-glare, factory-correct appearance.
• Purpose-built for the CZ 527’s 16mm dovetail receiver.
• Style is a specialty scope ring requiring no separate base.

Frequently Asked Questions

Do these rings require a separate base? No, they mount directly onto the CZ 527’s dovetail receiver without needing a base.

What hardware secures the scope? Four T-15 Torx-style socket cap screws, torqued to 25 in/lb, secure the scope in the rings.

Will these rings fit a CZ 550? No, this model is sized for the CZ 527’s 16mm dovetail; the CZ 550 uses a different 19mm dovetail ring.

Buy the Warne CZ 527 Scope Rings

Get a precise, permanent scope mount built specifically for your CZ 527. Order this Warne ring set from our scope rings selection, with fast, insured shipping from our Lubbock, Texas gun shop.