The MEC Bullet Puller (MEC part no. 1311095) disassembles loaded ammunition without a press: insert the cartridge with the correct-size cap piece, then strike the tool against a hard, flat surface to separate the bullet from the case. It’s a simple, portable way to safely break down a bad handload or recover components without tying up your press for a pulling job.

Key Specifications

• Disassembles cartridges using a strike-cap design, no press required.
• Uses interchangeable cap pieces sized to the cartridge being pulled.
• Portable enough to use anywhere, not just at a press-equipped bench.
• Doesn’t tie up your press for a pulling job.

Frequently Asked Questions

Do I need a press to use this bullet puller? No, it works by striking the tool against a hard, flat surface with the correct cap piece installed, no press required.

Does it come with caps for every caliber? The puller uses interchangeable cap pieces sized to the cartridge you’re pulling; make sure to match the cap to your caliber.

Buy the MEC Bullet Puller

Safely break down bad handloads or recover components without tying up your press. Order it from our Lubbock, Texas gun shop, where our gunsmithing tools selection stocks MEC bullet pullers and reloading accessories, with fast shipping to your door.