The Leupold Rifleman Gen2 1-inch low rings are a straightforward, well-made way to mount a 1-inch scope close to the bore (Leupold part no. 185534). They are machined to precise specifications from aircraft-grade aluminum for strength and repeatable alignment, and T-15 Torx screws make installation easy and secure. The low height suits scopes with smaller objective lenses on flat-topped rifles where a low cheek weld matters. Leupold backs the Rifleman line with a lifetime guarantee.

Key Specifications

• Ring diameter is 1 inch, sized for standard 1-inch scope tubes.
• Ring height style is Low, which keeps the scope close to the receiver for a lower cheek weld.
• Ring height measures .61 inch, the figure to check against your objective bell and barrel clearance.
• Material is aircraft-grade aluminum, lightweight yet strong enough for repeatable alignment.
• Fasteners are T-15 Torx screws, which resist cam-out and make for an easy, secure installation.
• The pair weighs 1.8 ounces, adding very little to the rifle.
• Keeper clamp torque is 14 in-lbs, the setting for the clamp screws.
• Ring top screw torque is 26 in-lbs, the setting for the top screws that hold the scope.
• There is no base cant built into the rings, so they sit level on the base.
• The rings are guaranteed for life by Leupold.

Frequently Asked Questions

What size scope tube do these rings fit? They are made for 1-inch scope tubes. Scopes with 30mm or larger tubes need a different ring diameter.

How high do these rings sit? They are the Low height in the Rifleman Gen2 line, with a ring height of .61 inch.

What torque should I use? Leupold lists 14 in-lbs for the keeper clamp and 26 in-lbs for the ring top screws.

Buy the Leupold Rifleman Gen2 1-Inch Low Rings

Good rings do not draw attention, and that is the point of the Rifleman Gen2. They hold zero, install with common Torx tools and are backed for life. Order them with our other scope rings from our Lubbock, Texas shop for fast, direct shipping.