The Lee Factory Rifle Crimp Die, 6mm Remington (Lee part no. 90832) is a carbide factory crimp die built for Lee‘s single-stage and turret press lineup, sized specifically for 6mm Remington rifle cases. Its carbide sizing ring post-sizes the loaded round while the crimp is applied, so the finished cartridge chambers as freely as one straight from the factory instead of needing extra sizing passes. Because the crimp comes from squeezing the case mouth rather than relying on a cannelure, it works on a wide range of bullet styles, including jacketed bullets that don’t have a crimp groove cut into them at all. Crimp amount is set with a simple adjustment screw, so dialing in more or less bite on the case mouth takes seconds on the bench.

Key Specifications

• Sized specifically for 6mm Remington rifle brass.
• A carbide sizing ring post-sizes the case at the same time the crimp is applied.
• Produces a round that chambers as freely as one straight from the factory.
• Works on a wide range of bullet styles, including jacketed bullets with no cannelure.
• Crimp amount is set with a simple adjustment screw, no extra tools needed.
• Shipping weight runs about 0.39 lb for the die alone.
• Like the rest of Lee’s die lineup, it’s manufactured in the USA.

Frequently Asked Questions

What does this crimp die do for 6mm Remington? It post-sizes the loaded round with a carbide ring while applying the crimp, so the finished cartridge chambers as freely as a factory round.

Does it work on bullets without a cannelure? Yes — the crimp comes from squeezing the case mouth itself, so it works on jacketed bullets that have no crimp groove.

Buy the Lee Factory Rifle Crimp Die, 6mm Remington

Add this factory crimp die to your 6mm Remington die set for a finishing crimp that chambers like a factory round every time. Order it from our Lubbock, Texas gun shop for quick, insured shipping, and browse our reloading dies selection for the rest of your die lineup.