The DNZ Marlin XL7, Winchester 70 1-Inch Low Scope Mount is a black two-piece scope mount from DNZ that sets 1-inch rings at low height on Marlin XL7/XS7 and Winchester 70 rifles (DNZ part no. 2W71L). DNZ machines the Game Reaper 2 line from 6061-T6 billet aluminum in the USA, and each front and rear mount is cut for one receiver pattern, so the fit is the first thing to confirm. At low height the scope tube centerline sits .92 inch above the receiver, which is the number to compare against your scope’s objective bell and your stock. It suits a Marlin or Winchester 70 hunting rifle that takes a standard 1-inch scope. The maker’s own specifications are listed below so you can check them against your rifle before ordering.

Key Specifications

• The mount is made for Marlin XL7 and XS7 and Winchester 70 long, short and WSM actions (it will not fit SSA or WSSM actions), so the base pattern matches those receivers.
• Rings are sized for a 1-inch scope tube, so the scope clamps in without extra inserts.
• Mount height is low at .92 inch from the top of the receiver to the centerline of the scope tube, the figure to match against your objective bell.
• The finish is black, a low-glare look that suits most blued and synthetic rifles.
• It is a two-piece mount, a separate front and rear base with a ring on each, so you can place the scope for your eye relief.
• The rings are .63 inch wide with two screws per ring, the standard-ring layout.
• The front and rear mounts are not the same part, because the back mount is taller than the front on this receiver, so install each in its own position.

Frequently Asked Questions

Will it fit a Winchester 70 or Marlin short action? DNZ lists it for Winchester 70 and Marlin XL7 and XS7 long, short and WSM actions. DNZ states it will not fit the SSA or WSSM actions.

What screws and tools does it use? Base screws are 6-48 x 1/4 inch and use a 7/64-inch Allen wrench. Ring screws are 6-40 x 5/8 inch and use a 7/64-inch Allen wrench.

What scope rings and height does it use? It uses 1-inch rings at low height, which DNZ lists at .92 inches from the top of the receiver to the centerline of the scope tube.

Buy the DNZ Game Reaper 2 Marlin XL7/XS7 and Winchester 70 1-Inch Low Scope Mount, Black

A mount that lines up with your receiver holes saves a lot of trial and error at the bench. Order it from our Lubbock, Texas gun shop for fast, insured shipping, and see more scope accessories and parts while you are here.