The Area 419 Billet Loading Block for magnum-sized brass, in clear anodized finish (Area 419 part no. 419-BASIC-MAG), is machined in-house from 6061-T6 aluminum and anodized to hold up to regular bench abuse. Rubber pads on the bottom keep the block from sliding around while you’re loading. Each hole is 0.500 inch deep and sized to 0.560 inch in diameter for a tight fit around magnum bolt-face cases, which helps prevent tipping, and a small divot at the bottom of each hole catches stray powder kernels and helps prevent primer accidents. The block measures 9.5 by 4 by 5/8 inches overall.

Key Specifications

• Machined from 6061-T6 aluminum with a clear anodized finish.
• Hole diameter is sized to 0.560 inch for magnum-sized brass.
• Holes are 0.500 inch deep for a tight, tip-resistant fit.
• Includes rubber pads on the bottom to prevent sliding.
• Measures 9.5 x 4 x 5/8 inches overall.

Frequently Asked Questions

What brass is this loading block sized for? Magnum-sized cases, with holes machined to 0.560 inch diameter.

Does this block stay in place on the bench? Yes, rubber pads on the bottom keep it from sliding around.

Buy the Area 419 Billet Loading Block, Magnum Clear Anodized

Magnum cases need a loading block with holes cut to their exact diameter to stay upright while you charge them, and this block is machined precisely for that job. Order this Area 419 block from our reloading accessories selection and we’ll ship it fast from our Lubbock, Texas gun shop.