The ATN TICO Scope Mounting System, 44mm Objective (American Technologies Network part no. ACCOSMS44534) is sized specifically to clear a 44mm objective bell while clamping onto a 53.4mm diameter tube section behind it. That combination of clearance and clamp size makes it a purpose-built mounting solution for optics that would otherwise sit too close to the barrel or rail to fit a generic ring set. At roughly 8.2 inches overall, it gives enough length to position the optic properly for eye relief while keeping the mount itself straightforward to install.

Key Specifications

• Clears a 44mm objective bell.
• Clamps onto a 53.4mm diameter tube section.
• Measures approximately 8.2 inches overall.
• Purpose-built as a dedicated scope mounting system, not a generic ring set.

Frequently Asked Questions

Will this fit any scope with a 44mm objective? This mount is sized specifically for a 44mm objective bell and a 53.4mm clamp diameter, so confirm both measurements against your scope before ordering.

Is this a full mount or just rings? This is a complete mounting system built around the objective bell and clamp diameter, not a standalone ring set.

Buy the ATN TICO Scope Mounting System, 44mm Objective

Large-objective optics need a mount cut to their exact clearance dimensions, and this ATN TICO system is built to those specifications. Order it from ATN through our optics accessories lineup and our Lubbock, Texas team will get it on its way as soon as it’s ready.