The Midwest Industries Scope Mount for Ruger 10/22 (Midwest Industries part no. MI-1022SM) is a one-piece Picatinny base built to bolt directly onto the factory receiver holes of the Ruger 10/22 and its clones. Finished in matte black, it gives rimfire shooters a modern, standardized rail for mounting a red dot or compact scope instead of relying on aftermarket dovetail rings. Midwest Industries builds its mounts to tight tolerances so the base sits flush and true without shimming. It’s a solid, no-fuss upgrade for a 10/22 used for plinking, small game, or training. Check out additional Midwest Industries gear in our catalog.

Key Specifications

• It’s a genuine 1-Piece Base, so there’s no alignment work between separate front and rear sections.
• The base measures 4.65 inches long, enough room for most red dot and scope ring footprints.
• The rail follows the Picatinny Rail pattern, the universal standard for scope and red dot mounts.
• It’s finished in matte black to match most factory 10/22 finishes.
• Mounting is direct to the receiver, using the factory-drilled holes on 10/22 rifles and clones.

Frequently Asked Questions

Will this fit a 10/22 clone, or only the factory Ruger receiver? It’s made to fit the Ruger 10/22 receiver as well as common clones that share the same factory mounting hole pattern.

Does this mount accept red dot optics? Yes. The Picatinny rail pattern accepts any red dot or scope ring built to that standard.

Is this a two-piece or one-piece base? It’s a one-piece base, which keeps front and rear alignment consistent without separate mounting sections.

Buy the Midwest Industries Scope Mount for Ruger 10/22

Put a proper Picatinny rail on your 10/22 and stop fighting dovetail clamp mounts. Order it from our Lubbock, Texas gun shop for fast, insured direct shipping. Explore our other Scope Bases picks while you’re here.