Redding Type S Elite Die Set, 6mm Dasher

The Redding Type S Elite Die Set for 6mm Dasher (Redding part no. 60648) gives precision handloaders a complete three-die setup built around Redding’s interchangeable bushing technology. The set pairs a Type S Bushing Full Length Die with a Type S Bushing Neck Die and a Redding Competition Seating Die, letting a reloader control both neck sizing and bullet seating with the same tight tolerances competitive shooters expect. Because the bushings are interchangeable, neck diameter and tension can be dialed in to an increment of 0.001 inch for cartridge brass that behaves the same load after load.

Key Specifications

• Includes a Type S Bushing Full Length Die for complete case resizing.
• Includes a Type S Bushing Neck Die for neck-only sizing when full-length sizing is not needed.
• Includes a Redding Competition Seating Die for precise, concentric bullet seating.
• Interchangeable sizing bushings adjust neck diameter and tension in 0.001-inch increments.
• Chambered specifically for 6mm Dasher, a benchrest and long-range wildcat cartridge.
• Set ships at approximately 1.8 lbs.

Frequently Asked Questions

What three dies come in this set? A Type S Bushing Full Length Die, a Type S Bushing Neck Die, and a Redding Competition Seating Die.

How precisely can neck tension be adjusted? The interchangeable bushings allow neck diameter and tension to be controlled in 0.001-inch increments.

What cartridge is this die set built for? It is chambered specifically for 6mm Dasher.

Buy the Redding Type S Elite Die Set for 6mm Dasher

6mm Dasher shooters chasing tighter neck tension control will appreciate having all three Type S Elite dies matched to one chambering. Order it from our Lubbock, Texas gun shop for fast, insured direct shipping, and browse Redding‘s full lineup of reloading dies for other chamberings.