The DNZ Game Reaper Remington 7400/7600/750 30mm Medium Mount is a black one-piece scope mount from DNZ that sets 30mm rings at medium height on Remington 7400, 7600, 7615 and 750 rifles (DNZ part no. 56700). DNZ machines the Game Reaper line from a solid block of billet aluminum in the USA, with the base and rings made as one piece for a specific receiver pattern, so the fit is the first thing to confirm. At medium height the scope tube centerline sits 1.06 inch above the receiver, which is the number to compare against your scope’s objective bell and your stock. It suits a Remington pump or semi-auto hunting rifle that carries a 30mm scope. The maker’s own specifications are listed below so you can check them against your rifle before ordering.

Key Specifications

• The mount is made for Remington 7400, 7600, 7615 and 750 rifles (DNZ also lists the Benelli Slug SBEII, M2 and Nova for this mount), so the base pattern matches those receivers.
• Rings are sized for a 30mm scope tube, the larger diameter used on many modern long-range and hunting scopes.
• Mount height is medium at 1.06 inch from the top of the receiver to the centerline of the scope tube, the figure to match against your objective bell.
• The finish is black, a low-glare look that suits most blued and synthetic rifles.
• It is a one-piece unit with the base and rings machined together, so the rings stay aligned with each other.
• Outside to outside, the rings measure 3.92 inches, the span to weigh against your scope’s tube length.
• The mount fits both left- and right-hand versions of the rifle, so one part number covers either hand.
• Hole-to-hole spacing is .60, 2.05 and .86 inch, the pattern to compare against your receiver before ordering.
• Base screws are 8-40 x 1/4 inch and take a 9/64-inch Allen wrench, so check what your receiver is drilled and tapped for.
• Ring screws are 6-40 x 5/8 inch and take a 7/64-inch Allen wrench.

Frequently Asked Questions

Which Remington rifles does this mount fit? DNZ lists it for the Remington 7400, 7600, 7615 and 750, and for the Benelli Slug SBEII, M2 and Nova. Its hole pattern is .60, 2.05 and .86 inch.

What scope rings and height does it use? It uses 30mm rings at medium height, which DNZ lists at 1.06 inches from the top of the receiver to the centerline of the scope tube.

What screws and tools does it use? Base screws are 8-40 x 1/4 inch and use a 9/64-inch Allen wrench. Ring screws are 6-40 x 5/8 inch and use a 7/64-inch Allen wrench.

Buy the DNZ Game Reaper Remington 7400/7600/7615/750 30mm Medium One-Piece Scope Mount, Black

A mount that lines up with your receiver holes saves a lot of trial and error at the bench. Order it from our Lubbock, Texas gun shop for fast, insured shipping, and see more scope accessories and parts while you are here.