The Weaver 1-Piece Extended Multi-Slot Picatinny Scope Base Savage 110 SA 8-40 0MOA Matte Clam is a one-piece extended (multi-slot) scope base built to fit the Savage 110 short-action receiver (8-40 screw spacing) (manufacturer part number 99466).

Key Specifications

• Engineered to fit the Savage 110 short-action receiver (8-40 screw spacing).
• Finished in matte to match most factory rifle finishes.
• One-piece construction for maximum rigidity and simplified alignment versus a two-piece base.
• Extended, multi-slot profile that opens up additional ring-position choices for correct eye relief.
• Part of the Weaver Multi-Slot product line.
• Overall length is approximately 10.25 inches.
• This is a 0 MOA (flat) base — no built-in elevation cant, suited to standard hunting ranges rather than extreme long-range shooting.
• Packaged in a clamshell retail card.
• Adds about 1 inch of forward base length versus a standard base, opening up more ring-position choices for eye relief.
• Constructed from 6061-T6 aluminum.

Frequently Asked Questions

Will this fit my rifle?

This scope base is built specifically for the Savage 110 short-action receiver (8-40 screw spacing). Confirm your receiver matches that action/model before ordering, since scope mounting hardware is not interchangeable across unrelated actions.

Do I need gunsmithing tools to install this?

Installation uses standard hand tools (a torque wrench or hex driver is recommended); no drilling or gunsmith fitting is required for the Savage 110 short-action receiver (8-40 screw spacing) interface.

Does this come with mounting hardware?

Yes, the mounting screws needed to attach it to a compatible receiver or rail are included.

Buy the Weaver 1-Piece Extended Multi-Slot Picatinny Scope Base Savage 110 SA 8-40 0MOA Matte Clam

Order from Schaefer Defense and shop more Weaver scope rings, bases, and mounting hardware, or browse our full Scope Bases selection.