The Pearce Grip PG-9EZ is a grip extension engineered for the S&W M&P Shield EZ, replacing the factory magazine base plate to add approximately 1/2-inch of additional gripping surface for a steadier, more comfortable hold.

Key Specifications

• Built by Pearce Grips specifically to fit the S&W M&P Shield EZ.
• Directly replaces the factory magazine base plate for a clean, no-gunsmithing installation.
• Adds approximately 1/2-inch of additional gripping surface without altering the magazine’s rated capacity.
• Molded from durable black polymer that stands up to daily carry and range use.
• It is molded specifically for the EZ frame’s grip angle.
• Retains the factory texture pattern for a seamless, factory-look fit.
• Ships as a single drop-in replacement part, ready to install at home.
• Part of Pearce Grips’ line of drop-in magazine ergonomics upgrades.
• Sized for magazines chambered in 9mm.
• Measures approximately 2.7 inches in overall length once installed.

Frequently Asked Questions

Does this grip extension increase magazine capacity? No. This extension replaces the factory base plate and adds gripping surface only; it does not change the magazine’s rated round count.

Will it fit other S&W M&P Shield EZ variants? Fitment is limited to the models listed in the specifications above; always confirm against your specific pistol and magazine before ordering.

Buy the Pearce Grip Extension for S&W M&P Shield EZ

Ships fast from a Lubbock, TX gun shop on the Pearce Grip Extension for S&W M&P Shield EZ from Pearce Grips, part of our Pistol Grips selection. Add it to your carry setup for a steadier, more confident grip.