The Pearce Grip PG-48 is a grip extension engineered for the Glock 43X and Glock 48, replacing the factory magazine base plate to add approximately 5/8-inch of additional length for a steadier, more comfortable hold.

Key Specifications

• Built by Pearce Grips specifically to fit the Glock 43X and Glock 48.
• Directly replaces the factory magazine base plate for a clean, no-gunsmithing installation.
• Adds approximately 5/8-inch of additional length without altering the magazine’s rated capacity.
• Molded from durable black polymer that stands up to daily carry and range use.
• An ergonomic curve is molded in for a more natural grip angle.
• Retains the factory texture pattern for a seamless, factory-look fit.
• Ships as a single drop-in replacement part, ready to install at home.
• Part of Pearce Grips’ line of drop-in magazine ergonomics upgrades.
• Sized for magazines chambered in 9mm.
• Ships at a shipping weight of about 0.06 lb, light enough to carry as a spare.

Frequently Asked Questions

Does this grip extension increase magazine capacity? No. This extension replaces the factory base plate and adds gripping surface only; it does not change the magazine’s rated round count.

Will it fit other Glock 43X variants? Fitment is limited to the models listed in the specifications above; always confirm against your specific pistol and magazine before ordering.

Buy the Pearce Grip Extension for Glock 43X and Glock 48

Ships fast from a Lubbock, TX gun shop on the Pearce Grip Extension for Glock 43X and Glock 48 from Pearce Grips, part of our Glock Grips selection. Add it to your carry setup for a steadier, more confident grip.