Lee Universal Shell Holder #26, 4.6×30 and Similar

The Lee Universal Shell Holder #26, 4.6×30 and Similar (Lee part no. 91993) is a universal-fit shell holder from Lee Precision, made in the United States to work in most brands of single-stage and turret presses. It is sized for the 4.6×30 and Similar case head, holding the cartridge square to the die through sizing, expanding, seating, and crimping. Because it is a universal design rather than a press-specific part, it is a straightforward swap if you run more than one press brand at the bench.

Key Specifications

• Universal press fit works in most brands of single-stage and turret presses, not just Lee’s own.
• Sized for 4.6×30 and Similar and similar cases sharing the same case-head diameter.
• Made in the United States manufactured by Lee Precision to consistent tolerances.
• Snap-in shell-holder body seats into the press ram without extra tools or adapters.
• Ships at 0.04 lb light enough to keep several calibers on hand without cluttering the bench.

Frequently Asked Questions

Will this fit a non-Lee press? Yes, it is a universal shell holder built to work in most brands of single-stage and turret presses, not just Lee’s.

What is this shell holder sized for? It is sized for 4.6×30 and Similar and other cases that share the same case-head diameter.

Buy the Lee Universal Shell Holder #26, 4.6×30 and Similar

Order the Lee Universal Shell Holder #26, 4.6×30 and Similar from our Lubbock, Texas gun shop for fast, reliable shipping straight to your reloading bench. Check out our full reloading equipment lineup for the rest of your press setup.